湖北汽车工业学院 汽车智能制造学院,湖北 十堰 442002
邱培桀(2002—),男,硕士生(在读),研究方向新能源动力电池热管理,E-mail:1046714044@qq.com;
王永泉(1979—),副教授,研究方向为智能制造装备设计技术、机械产品设计技术,E-mail:30099516@qq.com。
收稿:2026-09-08,
修回:2026-09-25,
网络首发:2026-10-12,
移动端阅览
邱培桀, 王永泉, 张嘉豪, 等. 相位调控与波长非对称波纹液冷板热流性能研究[J]. 储能科学与技术, XXXX, XX(XX): 1-13.
QIU Peijie, WANG Yongquan, ZHANG Jiahao, et al. Thermo-Hydraulic Performance of Phase-Shifted and Wavelength-Asymmetric Corrugated Cooling Plates[J]. Energy Storage Science and Technology, XXXX, XX(XX): 1-13.
邱培桀, 王永泉, 张嘉豪, 等. 相位调控与波长非对称波纹液冷板热流性能研究[J]. 储能科学与技术, XXXX, XX(XX): 1-13. DOI: 10.19799/j.cnki.2095-4239.2026.0790.
QIU Peijie, WANG Yongquan, ZHANG Jiahao, et al. Thermo-Hydraulic Performance of Phase-Shifted and Wavelength-Asymmetric Corrugated Cooling Plates[J]. Energy Storage Science and Technology, XXXX, XX(XX): 1-13. DOI: 10.19799/j.cnki.2095-4239.2026.0790.
针对高功率密度动力电池在高倍率放电工况下散热能力不足、温度均匀性差的问题,建立电池液冷板三维共轭传热模型,在雷诺数(
Re
) 272~2445研究范围内,以直流道(SC)为基准,系统对比了对称波纹(SWC)、反相波纹(IPWC)、错相波纹(PSWC)及波长非对称波纹(WAWC)液冷板的热流综合性能。通过相位调控和波长非对称两种强化策略,结合熵产理论,揭示了不同强化策略传热与阻力的权衡关系及其随雷诺数的演变规律。结果表明,不同流道结构的综合热流性能随
Re
呈现不同变化特征。
Re
= 815时PSWC获得最高性能评价准则(PEC) 1.399;
Re
= 1902和2445时WAWC的PEC分别为1.348和1.320,高于对应工况下PSWC的1.313和1.288。与PEC评价结果不同,WAWC在全部研究
Re
工况下均具有最高的面积优度因子(
j/f
),其相对SC的增幅为5.88%~28.51%,表明其在换热强化与流动阻力之间具有较稳定的匹配特征。熵产分析进一步揭示,PSWC在强化换热的同时伴随较高的摩擦不可逆损失,而WAWC在较高换热水平下具有较低的摩擦不可逆损失。此外,波长非对称比对WAWC热流性能呈非单调影响,据此基于CFD数据建立包含非对称比二次项的经验关联式,可用于本文参数范围内
Nu
和
f
的初步估算。
Aiming to address insufficient heat dissipation and poor temperature uniformity of high-power-density power batteries under high-rate discharge
a three-dimensional conjugate heat transfer model of a battery liquid cooling plate was established. Over a Reynolds number (
Re
) range of 272~2445
four corrugated-channel configurations
na
mely symmetric wavy channel (SWC)
inverse-phase wavy channel (IPWC)
phase-shifted wavy channel (PSWC)
and wavelength-asymmetric wavy channel (WAWC)
were compared against a straight channel (SC). The two enhancement strategies were analyzed using entropy generation theory to reveal the trade-off between heat transfer and flow resistance and its evolution with
Re
. The results show that the thermo-hydraulic performance of different channel configurations exhibits distinct variations with
Re
. At
Re
= 815
the PSWC achieves the highest PEC of 1.399. At
Re
= 1902 and 2445
the PEC values of the WAWC are 1.348 and 1.320
respectively
higher than those of the PSWC
which are 1.313 and 1.288
respectively. In contrast to the PEC results
the WAWC exhibits the highest
j/f
over the entire investigated Re range
with increases of 5.88%~28.51% relative to the SC
indicating a relatively stable balance between heat transfer enhancement and flow resistance. Entropy generation analysis further reveals that PSWC achieves enhanced heat transfer at the expense of relatively high frictional irreversible losses
whereas WAWC exhibits lower frictional irreversible losses while maintaining a higher level of heat transfer. In addition
the wavelength asymmetry ratio has a non-monotonic effect on the thermal-hydraulic performance of WAWC. Accordingly
an empirical correlation incorporating the quadratic term of the asymmetry ratio was established based on the CFD data
which can be used for preliminary estimation of
Nu
and
f
within the parameter range investigated in this study.
章正哲, 张恒运. 基于高效液冷技术的锂离子电池热管理研究进展[J]. 电源技术, 2025, 49(1): 14-25. DOI:10.3969/j.issn.1002-087X.2025.01.002.
ZHANG Z Z, ZHANG H Y. Review on the thermal management of lithium ion batteries based on energy-efficient liquid cooling techniques[J]. Chinese Journal of Power Sources, 2025, 49(1): 14-25. DOI:10.3969/j.issn.1002-087X.2025.01.002.
WU C, SUN Y, TANG H, et al. A review on the liquid cooling thermal management system of lithium-ion batteries[J]. Applied Energy, 2024, 375: 124173. DOI:10.1016/j.apenergy.2024.124173.
AKBARZADEH M, KALOGIANNIS T, JAGUEMONT J, et al. A comparative study between air cooling and liquid cooling thermal management systems for a high-energy lithium-ion battery module[J]. Applied Thermal Engineering, 2021, 198: 117503. DOI:10.1016/j.applthermaleng.2021.117503.
陈雅, 范立云, 李晶雪, 等. 二次流蛇形通道锂离子电池散热性能[J]. 储能科学与技术, 2023, 12(6): 1880-1889. DOI:10.19799/j.cnki.2095-4239.2023.0006.
CHEN Y, FAN L Y, LI J X, et al. Research on heat dissipation of lithium-ion batteries with secondary flow serpentine channel[J]. Energy Storage Science and Technology, 2023, 12(6): 1880-1889. DOI:10.19799/j.cnki.2095-4239.2023.0006.
刘显茜, 孙安梁, 田川. 基于仿生翅脉流道冷板的锂离子电池组液冷散热[J]. 储能科学与技术, 2022, 11(7): 2266-2273. DOI:10.19799/j.cnki.2095-4239.2021.0670.
LIU X X, SUN A L, TIAN C. Research on liquid cooling and heat dissipation of lithium-ion battery pack based on bionic wings vein channel cold plate[J]. Energy Storage Science and Technology, 2022, 11(7): 2266-2273. DOI: 10.19799/j.cnki.2095-4239.2021.0670.
刘欢欢, 任晓龙, 张泽斌. 锂离子电池仿生树状通道液冷板数值优化[J]. 包装工程, 2023, 44(19): 273-282. DOI:10.19554/j.cnki.1001-3563.2023.19.035.
LIU H H, REN X L, ZHANG Z B. Numerical optimization of bionic tree-like channel liquid cold plate on lithium-ion battery[J]. Packaging Engineering, 2023, 44(19): 273-282. DOI:10.19554/j.cnki.1001-3563.2023.19.035.
李君浩, 任晓龙, 杨炯, 汤松臻. 锂电池冷板新波形微流道传热特性研究及结构优化[J]. 西安交通大学学报, 2024, 58(11): 14-26. DOI:10.7652/xjtuxb202411002.
LI J H, REN X L, YANG J, TANG S Z. Study on heat transfer characteristics and structural optimization of new wavy microchannel for lithium battery cold plate[J]. Journal of Xi'an Jiaotong University, 2024, 58(11): 14-26. DOI:10.7652/xjtuxb202411002.
唐程波, 锁要红, 何昭坤. 基于正弦函数的液冷板上流体流向对锂离子电池散热性能的影响[J]. 储能科学与技术, 2023, 12(8): 2547-2555. DOI:10.19799/j.cnki.2095-4239.2023.0141.
TANG C B, SUO Y H, HE Z K. Effect of fluid-flow direction on heat dissipation from lithium-ion batteries based on sine-function cooling plate[J]. Energy Storage Science and Technology, 2023, 12(8): 2547-2555. DOI:10.19799/j.cnki.2095-4239.2023.0141.
AKBARZADEH M, RASHIDI S, ESFAHANI J A. Influences of corrugation profiles on entropy generation, heat transfer, pressure drop, and performance in a wavy channel[J]. Applied Thermal Engineering, 2017, 116: 278-291. DOI:10.1016/j.applthermaleng.2017.01.076.
ZHU Q, LIU X, ZENG J, et al. Numerical study of heat transfer and fluid flow in a symmetric wavy microchannel heat sink reinforced by slanted secondary channels[J]. Case Studies in Thermal Engineering, 2025, 65: 105605. DOI:10.1016/j.csite.2024.105605.
ZHANG L Y, DUAN R J, CHE Y, et al. A numerical analysis of fluid flow and heat transfer in wavy and curved wavy channels[J]. International Journal of Thermal Sciences, 2022, 171: 107248. DOI:10.1016/j.ijthermalsci.2021.107248.
SALEH Z M, JAFFAL H M. Comparative analysis of multichannel cold plates with various corrugated channel structures and dual flow outlets[J]. International Communications in Heat and Mass Transfer, 2025, 164: 108908. DOI:10.1016/j.icheatmasstransfer.2025. 108908.
LIU F, YANG Q, CHEN Y, et al. Optimum design of liquid-cooled plate with asymmetric corrugated channel for battery thermal management[J]. Engineering Applications of Computational Fluid Mechanics, 2026, 20(1): 2638917. DOI:10.1080/19942060.2026.2638917.
BERNARDI D, PAWLIKOWSKI E, NEWMAN J. A general energy balance for battery systems[J]. Journal of the Electrochemical Society, 1985, 132(1): 5-12. DOI:10.1149/1.2113792.
SHIH T H, LIOU W W, SHABBIR A, et al. A new k-ε eddy viscosity model for high Reynolds number turbulent flows[J]. Computers & Fluids, 1995, 24(3): 227-238. DOI:10.1016/0045-7930(94)00032-T.
TANOUGAST A, HRICZÓ K. Comparison of turbulence models in the simulation of fluid flow in corrugated channel[J]. Advances in Science and Technology, 2025, 165: 53-64. DOI:10.4028/p-7SAkva.
PANCHAL S, GUDLANARVA K, TRAN M K, et al. Numerical simulation of cooling plate using turbulence model to cool down large-sized graphite/LiFePO4 battery at high C-rates[J]. World Electric Vehicle Journal, 2022, 13(8): 138. DOI:10.3390/wevj13080138.
BEJAN A. Entropy generation minimization: the method of thermodynamic optimization of finite-size systems and finite-time processes[M]. Boca Raton: CRC Press, 1996.
WEI W H, LUO Z, QIAO S X, et al. Analysis and design of module-level liquid cooling system for rectangular Li-ion batteries[J]. International Journal of Heat and Mass Transfer, 2024, 225: 125435. DOI:10.1016/j.ijheatmasstransfer.2024.125435.
SUI Y, LEE P S, TEO C J. An experimental study of flow friction and heat transfer in wavy microchannels with rectangular cross section[J]. International Journal of Thermal Sciences, 2011, 50(12): 2473-2482. DOI:10.1016/j.ijthermalsci.2011.06.017.
0
浏览量
0
下载量
0
CSCD
关联资源
相关文章
相关作者
相关机构
京公网安备11010102001997号